Calibrating module for local hyperthermia complex «Phoenix-2»
DOI: 10.21293/1818-0442-2016-19-4-125-128
Abstract: The objective of calibrating module is to heat needle heater and maintain its temperature on certain level with maximum deviation ±0.1 °C. The purpose is achieved using precision temperature sensor and proportional-integral-derivative controller in automatic control system. According the test results, the static error does not exceed 0.04 °C.
Keywords: temperature stabilization, temperature, automatic control system
Authors and copyright holders:
—
For citation:
Han K. I., Semenov V. D., Pahmurin D. O., Kobzev A. V. Calibrating module for local hyperthermia complex «Phoenix-2». Doklady Tomskogo gosudarstvennogo universiteta sistem upravleniya i radioelektroniki, 2016, vol. 19, no. 4, pp. 125–128. DOI: 10.21293/1818-0442-2016-19-4-125-128
Last issue
-2025-1.jpg)
Editorial office address
Executive Secretary of the Editor’s Office
Editor’s Office: 40 Lenina Prospect, Tomsk, 634050, Russia
Phone / Fax: + 7 (3822) 701-582
Viktor N. Maslennikov
Executive Secretary of the Editor’s Office
Editor’s Office: 40 Lenina Prospect, Tomsk, 634050, Russia
Phone / Fax: + 7 (3822) 51-21-21 / 51-43-02
Subscription for updates
