Waveguide dual-mode bandpass filters based on half-wave resonators with stubs

Download article in PDF format

Authors: Sorkin A. A.

Annotation: A waveguide half-wave resonator with a stub and filter designs based on it are considered. It is shown that the location of the stub in the center of a half-wave resonator leads to an increase in signal attenuation near the passband of filters compared to filters based on half-wave resonators. Using this type of resonator, the pole can be obtained both below the passband and above. The geometric dimensions of the four- and eightsection filters with a symmetrical frequency response are given.

Keywords: waveguide resonator, stub, attenuation pole, band pass filter

Editorial office address

Executive Secretary of the Editor’s Office

 Editor’s Office: 40 Lenina Prospect, Tomsk, 634050, Russia

  Phone / Fax: + 7 (3822) 701-582

  journal@tusur.ru

 

Viktor N. Maslennikov

Executive Secretary of the Editor’s Office

 Editor’s Office: 40 Lenina Prospect, Tomsk, 634050, Russia

  Phone / Fax: + 7 (3822) 51-21-21 / 51-43-02

  vnmas@tusur.ru

Subscription for updates